The Multiboard electronics, sometimes referred to old electronics are usually used in the MKII and MKIV Brewers. Some of the earlier MKIII brewers may also be running the multiboard electronics. The multiboard electronics consist of the primary power supply¹ (PPS), secondary power supply, Card cage boards, and the heatsink.

¹Note, both multiboard and single board electronics both have an PPS, however the multiboard uses a 24V/15V/5V power supply while the single board electronics uses 24V/12V/5V power supply. The latest brewer's produced by Kip and Zonen (around Brewer # 250) uses the TDK-Lambda NV175 series power supply. The single Electronics board uses NV1-4G5TT, where the multiboard uses the NV14G5FF.

1. IO Board (A)
2. IO Board (B)
3. IO Board (C)
4. Microprocessor/RCA board
5. Clock Board
6. Analog to Digital Board
7. Photon Counter Board

Q: What are the differences between new vs old temperature circuit on the clock board?
A: Note the resistors on the top left of the boards below (New Vs Old). New temperature circuits, some resistors has been replaced with a jumper wire.

Q: What control goes to what connector?
A:

Q: How do I find out what what LED sensor is active?
A: Depending on what you're looking for, you can use one of the 3 commands in MM GET,800GET,544GET,1056. This will yield the following

Open in New Tab