Artemis is the Remote Sensing 3d printer.

The printer can be accessed here

Q: Which one is Extruder 1 vs Extruder 2
A: Extruder 1 is on the left, Extruder 2 is on the right

Q: The printer isn't starting at the right Z height, and the print head is digging into the bed/printing too high.
A: Run “_Probe Autolevel” when the hotend is at room temperature. If problem still doesn't go away, you will need to run the “First Probe” macro

Q: What needs to be done when you run the “First Probe” macro
A: Go to the web interface

1. Settings –> System Editor –> Delete “heightmap.csv” and “config-override.g”.
2. Press the Emergency STOP button on the top right corner.
3. Once connection is reestablished, run the First Probe macro.
4. When finish turn the printer off for 30 seconds and turn it back on.

Q: What software do I use to slice the files
A: Cura is a free software that can be used to slice the stl files into gcode. Artemis' profile can be downloaded at seemecnc's website