Differences

This shows you the differences between two versions of the page.

--- artemis [2021/12/20 17:04] – created reno
+++ artemis [2021/12/20 19:18] (current) – reno
@@ Line 4: / Line 4: @@
 The printer can be accessed [[artemis.hiitravel.ca|here]]
+====== Settings ======
+All settings are assuming the WHAM BAM flex plate build plate is used.
+^Brand^Line^Type^Hotend Temp^Bed Temp^Probe offset^
+|Filament.ca|EcoTough|PLA|200c-210c|60|0|
+|Filament.ca|EcoTough|PETG|220C|70|0|
+|WHAMBAM|Suggestions|PLA|190c-210c|70|squish on first layer|
+|WHAMBAM|Suggestions|PETG|240c-250c|70|squish on first layer|
+|WHAMBAM|Suggestions|PLA|230-250c|110-130|squish on first layer|
+*note: the WhamBAM are suggestions from the build surface. You should always try what the material suggest if it is a lower temperature first!*
 ====== FAQ ======
@@ Line 22: / Line 35: @@
 A: [[https://ultimaker.com/software/ultimaker-cura|Cura]] is a free software that can be used to slice the stl files into gcode. Artemis' profile can be downloaded at [[https://seemecnc.dozuki.com/Guide/Clean+Cura+Slicing+Software+Setup/141?lang=en|seemecnc's website]]
+Q: How do you change the probe offset?\\
+A: Settings --> System Edidtor --> config.g, look for line G31 P100 X0 Y0 Z0.0\\
+Change Z#.# as required. When the number is less negative, the lower the probe is, the more negative, the higher the probe is from the bed.