Canadian Brewer Spectrometer Network

This is an old revision of the document!

MM

TeleType Communications

MM sets the Brewer program to its teletype (terminal) mode, whereby the operator may communicate directly with the Brewer via the computer keyboard and a set of low level commands.
Exit from teletype mode by typing EXIT. See Appendix H for more explanation on the TeleType feature.

List of commands

Command	Variables	Usage	Description
A			Repeats the command. Usually use in conjunction with another command move. (I.E. R,0,7,5:O:A) Press home to delete twice to go exit.
B,x
B,2	This command controls the lamps
M,m,s
M,10,500	Moves motor m to step s. Note: when moving backwards (negative number) it will set that as the new reference point. Click here more motor information.
O		O
R,p1,p2,t
R,0,5,7	This command is used to measure the light intensity according to the variables setup. Often this command is combined with the O command to output the results. R,0,5,7:O
B,x		SL

TMAX		TMAX	Moves the top micrometer to the max position. This is to test to ensure the micrometer is able to move to the max range.
TMIN		TMIN	Moves the top micrometer to the min position. This is to test to ensure the micrometer is able to move to the max range.
BMAX		BMAX	Moves the bottom micrometer to the max position. This is to test to ensure the micrometer is able to move to the min range.
BMIN		BMIN	Moves the bottom micrometer to the min position. This is to test to ensure the micrometer is able to move to the min range.

For new electronics only

Command	Variables	Usage	Description
?<command> OR !<command>	See Operation Information		A variety of operational commands/status output for the brewer. for more.
I,m
I,9	This commands re-initializes the specified motor
SAVE		SAVE	Stores the current set of RAM configuration parameters

Table of Contents

MM

TeleType Communications

List of commands

For new electronics only