This is an old revision of the document!

MM

MM is a command that puts you into the teletype (terminal) of the Brewer Spectrometer.

List of commands

Command	Variables	Usage
B,x
B,2	This command controls the lamps
M,m,s
M,10,500	Moves motor m to step s. Note: when moving backwards (negative number) it will set that as the new reference point
O		O
R,p1,p2,t
R,0,5,7	This command is used to measure the light intensity according to the variables setup. Often this command is combined with the O command to output the results. R,0,5,7:O

Command	Variables	Usage	Description
I,m
I,9	This commands re-initializes the specified motor