Differences

This shows you the differences between two versions of the page.

--- mm [2025/08/12 13:11] – added E command reno
+++ mm [2025/08/12 13:54] (current) – reno
@@ Line 30: / Line 30: @@
   s refer to the number of steps to move
 |M,10,500|Moves motor m to step s. Note: when moving backwards (negative number) it will set that as the new reference point. [[motor|Click here more motor information]].|
-|N,s|s refers to the number of steps|N,500|(Used for [[singleboard|singleboard electronics]] only.) Moves both micrometer 1 and 2 to step s. Note: when moving backwards (negative number) it will set that as the new reference point. [[motor|Click here more motor information]].|
 |O| |O|This command outputs the number of counts returned in a measurement.
 |R,p1,p2,t|\\
@@ Line 91: / Line 90: @@
 . Zenith tracker
 |E,9|This command zeros the motor and return the number it takes to get to the LED. NOTE: This will not return the motor and will leave it at the LED|
-|
+|x,s1,s2|s1 and s2 refers to the number of steps to move for micrometer 1 and 2 respectively.|x,100,200|Moves both micrometer 1 and 2 to step s. Note: when moving backwards (negative number) it will set that as the new reference point. [[motor|Click here more motor information]].|
 ==== For new electronics only ====
@@ Line 111: / Line 111: @@
 |
 |I,9|This commands re-initializes the specified motor|
+|N,s|s refers to the number of steps|N,500|(Used for [[singleboard|singleboard electronics]] only.) Moves both micrometer 1 and 2 to step s. Note: when moving backwards (negative number) it will set that as the new reference point. [[motor|Click here more motor information]].|
 |SAVE|   |SAVE|Stores the current set of RAM configuration parameters|
 |?MZ10|   |?MZ10|Runs the command <key>?MOTOR.ZERO.POS[10]</key>|