====== Artemis ======

Artemis is the Remote Sensing 3d printer.

The printer can be accessed [[artemis.hiitravel.ca|here]]

====== Settings ======
All settings are assuming the WHAM BAM flex plate build plate is used.
^Brand^Line^Type^Hotend Temp^Bed Temp^Probe offset^
|Filament.ca|EcoTough|PLA|200c-210c|60|0|
|Filament.ca|EcoTough|PETG|220C|70|0|
|WHAMBAM|Suggestions|PLA|190c-210c|70|squish on first layer|
|WHAMBAM|Suggestions|PETG|240c-250c|70|squish on first layer|
|WHAMBAM|Suggestions|PLA|230-250c|110-130|squish on first layer|

*note: the WhamBAM are suggestions from the build surface. You should always try what the material suggest if it is a lower temperature first!*



====== FAQ ======
Q: Which one is Extruder 1 vs Extruder 2\\
A: Extruder 1 is on the left, Extruder 2 is on the right

Q: The printer isn't starting at the right Z height, and the print head is digging into the bed/printing too high.\\
A: Run "_Probe Autolevel" when the hotend is at room temperature. If problem still doesn't go away, you will need to run the "First Probe" macro

Q: What needs to be done when you run the "First Probe" macro\\
A: Go to the web interface  
  - Settings --> System Editor --> Delete "heightmap.csv" and "config-override.g".
  - Press the Emergency STOP button on the top right corner.
  - Once connection is reestablished, run the First Probe macro.
  - When finish turn the printer off for 30 seconds and turn it back on.

Q: What software do I use to slice the files\\
A: [[https://ultimaker.com/software/ultimaker-cura|Cura]] is a free software that can be used to slice the stl files into gcode. Artemis' profile can be downloaded at [[https://seemecnc.dozuki.com/Guide/Clean+Cura+Slicing+Software+Setup/141?lang=en|seemecnc's website]]

Q: How do you change the probe offset?\\
A: Settings --> System Edidtor --> config.g, look for line G31 P100 X0 Y0 Z0.0\\
Change Z#.# as required. When the number is less negative, the lower the probe is, the more negative, the higher the probe is from the bed.