zsf
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| zsf [2024/01/11 14:20] – andrew | zsf [2025/02/20 16:55] (current) – reno | ||
|---|---|---|---|
| Line 17: | Line 17: | ||
| * files: change the b file naming to reflect the brewer being analyzed as displayed above | * files: change the b file naming to reflect the brewer being analyzed as displayed above | ||
| * icf: enter the icf file to use in re-processing | * icf: enter the icf file to use in re-processing | ||
| - | * zsf: refers to one of the following 4 models based on location. | + | * zsf: refers to one of the following 4 models based on location. |
| * dtime: maximum time difference between ZS and DS (default 10) | * dtime: maximum time difference between ZS and DS (default 10) | ||
| * min mu: minimum air mass factor for DS/ZS pairs (default 1.2) | * min mu: minimum air mass factor for DS/ZS pairs (default 1.2) | ||
| Line 25: | Line 25: | ||
| * Rayleigh height (km): effective air height for Rayleigh calculations (default 5km) | * Rayleigh height (km): effective air height for Rayleigh calculations (default 5km) | ||
| * Difference between 03ETC and SLR6: the difference between O3ETC and SLR6 at calibration. This number can be found in the brewer’s icf file near the bottom of the text file. Refer to figure 3. | * Difference between 03ETC and SLR6: the difference between O3ETC and SLR6 at calibration. This number can be found in the brewer’s icf file near the bottom of the text file. Refer to figure 3. | ||
| + | |||
| + | ^zsf^Latitudes^Albedo^ | ||
| + | |& | ||
| + | |& | ||
| + | |& | ||
| + | |& | ||
| Save the newly updated cfg file to the test directory and rename it ds2zsxxx.cfg.\\ | Save the newly updated cfg file to the test directory and rename it ds2zsxxx.cfg.\\ | ||
zsf.1704982857.txt.gz · Last modified: 2024/01/11 14:20 by andrew