Differences

This shows you the differences between two versions of the page.

--- singleboard [2025/12/04 17:00] – reno
+++ singleboard [2026/07/14 15:11] (current) – added heater information reno
@@ Line 21: / Line 21: @@
 {{ :docs:kz_splitboard_pcb_layout_b.pdf |}}
+===== Heater Controller =====
+The heater is controlled by a separate board that is normally attached to the back of the foreoptics support in front of the stock location of the heater. The minium temperature can be controlled via J1
+^Jumper setting^Minimum temperature^
+|1-2|20°C|
+|2-3|10°C|
 ===== Mainboard Flat Cable Connections =====