ql
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| ql [2021/11/25 13:07] – mbrohart | ql [2024/01/17 13:08] (current) – removed pd from the command string as it is redundant reno | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| **Note**: Before using this section, please go through and understand how to perform the UV calibration via the {{ : | **Note**: Before using this section, please go through and understand how to perform the UV calibration via the {{ : | ||
| - | - Run the pre-calibration command string. \\ For all instruments aside from MKIII:< | + | - Run the pre-calibration command string. \\ For all instruments aside from MKIII:< |
| - | - With the calibration lamp on, check and make sure the zenith offset is correct via < | + | - With the calibration lamp on, check and make sure the zenith offset is correct via < |
| - Run an RU or restart dosbox so it won't run out of string space in the middle. | - Run an RU or restart dosbox so it won't run out of string space in the middle. | ||
| - | - Once the instrument is warmed up to temperature (Usually around 30c) run the uv calibration < | + | - Once the instrument is warmed up to temperature (Usually around 30c) run the uv calibration < |
| </ | </ | ||
| - | - For subsequent bulbs you can run the following without waiting for the bulb warmup (wait time included) < | + | - For subsequent bulbs you can run the following without waiting for the bulb warmup (wait time included) < |
ql.1637845670.txt.gz · Last modified: 2021/11/25 13:07 by mbrohart