Differences

This shows you the differences between two versions of the page.

--- multiboard [2025/09/16 14:49] – added cardcage motherboard pinouts reno
+++ multiboard [2025/11/27 11:59] (current) – [FAQ] reno
@@ Line 279: / Line 279: @@
 **Q:** What are the differences between new vs old temperature circuit on the clock board?\\
-**A:** Note the resistors on the top left of the boards below (New Vs Old). New temperature circuits, some resistors has been replaced with a jumper wire.\\
+**A:** Note the resistors on the top right of the boards below (New Vs Old). In the new temperature circuits, some resistors have been replaced with a jumper wire.\\
 {{:pictures:clock_board_old.vs.new.jpg?600|}}\\
-**Q:** How do I find out what what LED sensor is active?\\
+**Q:** How do I find out what LED sensor is active?\\
 **A:** Depending on what you're looking for, you can use one of the 3 commands in MM <key>GET,800</key><key>GET,544</key><key>GET,1056</key>. This will yield the following
 ^Bits^<key>GET,800</key>^<key>GET,544</key>^<key>GET,1056</key>^
@@ Line 293: / Line 293: @@
 |6|Down Switch Pressed| | |
 |7|Up Switch Pressed| | |
-{{iframefs>http://cbsn.hiitravel.ca/scripts/bits.php 330px noscroll}}
+{{iframefs>http://cbsn.hiitravel.ca:1080/scripts/bits.php 330px noscroll}}