firmware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| firmware [2024/01/29 16:47] – reno | firmware [2025/01/28 15:24] (current) – reno | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| Requirement: | Requirement: | ||
| - | * BrewCMD | + | * {{ : |
| * Firmware file (*.bin) in the same directory as brewCMD.exe | * Firmware file (*.bin) in the same directory as brewCMD.exe | ||
| * Corresponding Brewer config file (*.cfg) brewcmd.exe | * Corresponding Brewer config file (*.cfg) brewcmd.exe | ||
| Line 21: | Line 21: | ||
| - Load the config into the brewer (I.E. brew190.cfg)< | - Load the config into the brewer (I.E. brew190.cfg)< | ||
| - Instruct the Brewer to use the new config < | - Instruct the Brewer to use the new config < | ||
| + | - Wait about 5 minutes or so until the micrometer has stopped moving (otherwise you will get qserial timeout) | ||
| - Save the config to the eeprom < | - Save the config to the eeprom < | ||
| - BrewCMD will display a number (4 or 32 when the firmware is just installed depending on the version of the board) | - BrewCMD will display a number (4 or 32 when the firmware is just installed depending on the version of the board) | ||
firmware.1706546861.txt.gz · Last modified: 2024/01/29 16:47 by reno