| Type | Comment | count | priority | fname | location | serial | time | value | min | max |
|---|
| sc: | SC intensity too low ( 1/cy), skipping. | 2 | 3 | B18919.205 | RESOL | #205 | 00:09:20 | | 1 | -1 |
| rl: | 2019 190 00 23 39 Reset No -> Tepid from 2019 190 00 22 12 until 2057 153 17 55 18 . Counts: 1,0 | 1 | 3 | B18919.205 | RESOL | #205 | 06:28:39 | | 1 | -1 |
| rl: | 2019 190 00 23 40 New value set for watermark MOISTURE.HIGH: 20.372398 . | 1 | 3 | B18919.205 | RESOL | #205 | 06:28:41 | | 1 | -1 |
| rl: | 2019 190 00 23 40 Checksum bad in low level command. | 1 | 3 | B18919.205 | RESOL | #205 | 06:28:43 | | 1 | -1 |
| rl: | 2019 190 00 23 40 Motor #3: appears stuck with a reference sensor activated. | 1 | 3 | B18919.205 | RESOL | #205 | 06:28:46 | | 1 | -1 |
| rl: | 2019 190 00 23 40 Motor #11: appears stuck with a reference sensor activated. | 1 | 3 | B18919.205 | RESOL | #205 | 06:28:48 | | 1 | -1 |
| dsp: | Doing dispersion test with Hg (UV port) | 4 | 99 | B18919.205 | RESOL | #205 | 14:32:44 | | 1 | -1 |
| checkhg: | Last HG had to adjust the micrometer by at least 1 | 1 | 99 | B18919.205 | RESOL | #205 | 15:19:03 | | 1 | -1 |
| ez: | Illegal command (ez) in schedule , ignoring | 2 | 99 | B18919.205 | RESOL | #205 | 15:51:52 | | 1 | -1 |
| da_lo: | DEL key pressed | 2 | 99 | B18919.205 | RESOL | #205 | 22:23:45 | | 1 | -1 |
| az: | Azimuth discrepancy = 16000 | 4 | 99 | B18919.205 | RESOL | #205 | 22:30:00 | 16000 | -30 | 30 |
| si: | New SI, HC = 21, NC = 570 Old = 23 , 550 | 1 | 99 | B18919.205 | RESOL | #205 | 22:55:11 | | 1 | -1 |
| ds: | DS intensity too high ( 200604/cy) quitting. | 1 | 99 | B18919.205 | RESOL | #205 | 23:55:39 | | 1 | -1 |