| Type | Comment | count | priority | fname | location | serial | time | value | min | max |
|---|
| rl: | 2018 243 19 30 59 Reset No -> Tepid from 2018 243 19 25 04 until 2064 207 13 02 38 . Counts: 1,0 | 1 | 3 | B24318.194 | ALERT | #194 | 04:19:58 | | 1 | -1 |
| rl: | 2018 243 19 30 59 Checksum bad in low level command. | 1 | 3 | B24318.194 | ALERT | #194 | 04:19:59 | | 1 | -1 |
| rl: | 2018 243 19 31 00 Motor #3: appears stuck with a reference sensor activated. | 1 | 3 | B24318.194 | ALERT | #194 | 04:20:02 | | 1 | -1 |
| rl: | 2018 243 19 31 00 Motor #11: appears stuck with a reference sensor activated. | 1 | 3 | B24318.194 | ALERT | #194 | 04:20:04 | | 1 | -1 |
| rl: | 2018 243 22 09 43 New value set for watermark LOOP.RUN.TIME: 659.999990 millisec. | 1 | 3 | B24318.194 | ALERT | #194 | 04:20:29 | | 1 | -1 |
| ds: | HOME key pressed | 2 | 99 | B24318.194 | ALERT | #194 | 13:21:01 | | 1 | -1 |
| ds: | Going to menu | 2 | 99 | B24318.194 | ALERT | #194 | 13:21:05 | | 1 | -1 |
| sr: | Azimuth discrepancy = 1305 | 1 | 99 | B24318.194 | ALERT | #194 | 13:30:41 | 1305 | -30 | 30 |
| sr: | Azimuth Steps per revolution measured = 14596 | 1 | 99 | B24318.194 | ALERT | #194 | 13:32:27 | 14596 | 14600 | 14750 |
| sr: | Updating SR constant from 14595 to 14596 | 1 | 99 | B24318.194 | ALERT | #194 | 13:32:56 | 14596 | 14600 | 14800 |
| si: | New SI, HC = -16, NC = -780 Old = -16 , -780 | 1 | 99 | B24318.194 | ALERT | #194 | 13:41:37 | | 1 | -1 |